customer drawing raychem molded parts 305 constitution drive, menlo park, ca 94025 title: cable breakout boot, three entry unless otherwise specified di mensions are in inches. [metric dimensions are shown in brackets document no.: txxx-xxxfr rev: g tyco electronics reserves the right to amend this drawing at any time. users should evaluate the su itability of the product for their application. scale: none date: august 27, 2009 revised by: unguyen cage code: 06090 org. date : 5/7/07 eco # : 09-019755 file : txxx-xxxfr.doc size a sheet: 1 of 1 ? 2003-2009 tyco electronics corporation. all rights reserved if this document is printed it becomes uncont rolled. check for the latest revision. cable breakout boots, three entry table of dimensions, inch (mm) : part number (see note*) body id exp. rec?d. (a), min (b), max leg id exp. rec?d. (c), min (d), max length recovered min (e), body (f), leg rec?d. wall thickness ref (w) t3-9fr 0.90 (23) 0.36 (9) 0.33 (8) 0.12 (3) 2.0 (51) 0.7 (18) 0.04 (1.0) T14-23FR 1.20 (30) 0.69 (18) 0.50 (13) 0.18 (5) 2.3 (58) 1.0 (25) 0.09 (2.3) t23-50fr 1.20 (30) 0.69 (18) 0.50 (13) 0.18 (5) 2.3 (58) 1.0 (25) 0.09 (2.3) t42-100fr 1.70 (43) 0.90 (23) 0.82 (21) 0.30 (8) 2.3 (58) 1.2 (30) 0.12 (3.0) t60-150fr 1.70 (43) 0.90 (23) 0.82 (21) 0.30 (8) 2.3 (58) 1.2 (30) 0.12 (3.0) t150-300fr 2.40 (61) 1.40 (36) 1.25 (32) 0.50 (13) 3.5 (89) 1.6 (41) 0.12 (3.0) t200-400fr 2.40 (61) 1.40 (36) 1.25 (32) 0.50 (13) 3.5 (89) 1.6 (41) 0.12 (3.0) t-400fr 3.20 (81) 2.00 (51) 1.40 (36) 0.75 (19) 3.5 (89) 1.6 (41) 0.14 (3.6) t500-600fr 4.90 (124) 2.32 (59) 2.00 (51) 1.00 (25) 7.5 (191) 2.2 (56) 0.12 (3.0) note*: add ?na? to the end of part number if no adhesive is required material: heat shrinkable boot material in accordance with ?3 polyolefin factory applied sealant : factory applied hot melt adhesive is standard.
|
